5/2/2012 3:28:00 PM by Automotive And Commercial Locksmith
RESETTING THE CODE:
Please follow these instructions to reset the code on your Powerbolt 1000 unit.
- Remove the inner cover plate from the lock.
- Locate the small round program button near the left side of the circuit board (Red or Black).
- To program, the latch should be extended out in the lock position.
- Press the reset button once.
- Enter you 4 to 8 digit code on the exterior keypad follow by the by the lock button. You will hear a beep.
- Re enter the same 4 to 8 digit code to confirm, the latch should retract to confirm programming. This signals that your code has been accepted.
To enter a second code, follow the same procedures as in step 3, but this time press the reset button twice the enter your code.
CHANGING THE PASSWORD CODE:
Please follow instructions.
- Manually put the bolt in extended position.
- Press PROGRAM button once.
- Enter new 4 to 8 digit code follow by the LOCK button once
- Press PROGRAM button twice
- Enter the same new code follow by the LOCK button once
- Press PROGRAM button three times
- Enter the same new code follow by the LOCK button once
This steps will program only the new code you enter for your unit.
Locksmith Services (954) 347-9566